High temperature hot plate of TITANIUM  up to 600degree for continuous operation with PID-Temperature Controller or Programmer 

This high temperature hot plate reaches its max. temp. of 600degree within about 20 min. The upper plate consists of TITANIUM, overall dim. 280 x 200 mm. The marked area of constant temperature is 230 x 160 mm. Owing to a special insulation the device can be placed even on surfaces sensitive to heat. Metal sheets all around keep the casing temperature to a minimum. 

The insulated snap-lid ensures little loss of heat and short times of warming. Between the closed lid (inner surface Ceran'~ and the heating plate remain '26 mm, enabling an intensive heating of plain parts at high precise temperatures. The whole casing is made of stainless steel. 

The temperature regulator is connected by two plugged cables. 

PZ 28-3T is available either with a temperature controller or with a programmer. The temperature controller keeps the device constant to an adjusted temperature within the whole range. 

The programmer allows the control of certain programs including phases of heating up, constant temperature and cooling. 

Type:PZ 28-3TD
Titanium plate size:280 mm x 200 mm
Constant heating area:230 mm x 160 mm
Max. temperature:600degree
Voltage:230 Volt / 50..60 Hz
Power:2000 Watt
Spread of temperature:+-2 K
Cable length (standard):1,5 m
Overall dimensions:350 mm x 300 mm
Height:145 mm
Effective height with closed cover:26 mm*
Weight:10 kg

 *Covers for more effectiv e height on inquiry 

PROGRAMMER PR 5-3T 
The microprocessor controlled ramp regulator offers a comprehensive time/temperature regulation for the high temp. hot plate. Pressing the START key activates a program of up to 5 ramps. Max. 5 ramps (consisting of ramp time, constant temp. and time of constant temp.) can be programmed. 3 program sets can be loaded into the non-volatile memory. A programmed lead time enables the activation of the start up to 99 hours in advance. 
Every temperature and time parameter can be selected with its awn key. Consequently the setting is easy and clear. It is possible to pass over single ramps by setting the according 
parameter to '0'. Every set value can be controlled during a program. 
Back-up by an EEProm. The device is equipped with a change-over switch to continuous control; buzzer signal at the program. 

Equipment of PR5-3T and TR 28-3T 
2-poled main switch; individual adjustment of proportional range, derivative/integrating factor and cycle time; control range limitation (to avoid the setting of values not useful or harmful to an application); contact maker input, actual value correction, junction bush for high temperature hot plate, wattage power control 1...100%, unmterrrupted switching. 
Both regulators show the actual value constantly. Furthermore the programmer shows the remaining time of a ramp. When the SET key is pressed, the display changes to show the setpoint. 
On request the devices are available with a temperature limiter to avoid superheating. 

Type:PR 5-3T 

Voltage:230 Volt / 50..60 Hz 
Power:2200 Watt 
Cable length (standard):1,8 m 
Overall dimensions:305 mmx105mm 
Height:105 mm 
Display :14 mm  rot / red 
Control behaviour :PID/Zweipunkt 
Time ranges :9 h / 59 min 
Weight:2,7 kg